Aprilaire 8710 Specifications download pdf (Page 4)

6 7

3 LOCATION

The thermostat should be located in an area that

represents the ambient space temperature and within

100 feet of the control module. Do not install the

thermostat in an area where drafts are present, near

the floor, behind doors or on an external wall. Avoid

placing the thermsotat in areas where the air movement

is limited, affected by direct sunlight or other areas not

typical of the temperature in the space.

4 REMOVING THE SUB-BASE

Hold the sub-base with one hand, press the case as

shown below and pull the bottom of the thermostat

from the sub-base. Refer to the illustrations to the right.

THERMOSTAT

PRESS HERE TO RELEASE

CASE FROM SUB-BASE

5 INSTALLING THE SUB-BASE

The thermostat should be installed approximately 5 feet

above the floor.

Level the sub-base for appearance and use the wall

anchors and screws provided.

6 INSTALLING THE BATTERIES

Slide the battery cover off and install two AA batteries

included with the thermostat. Install the batteries with

the positive terminals to the right as shown. Replace

the battery cover.

The LCD will display the time of day, the setpoint

temperature and the room temperature.

1 2 3 4 5 6 7 8 9 10 11

No comments

Aprilaire 8710 Specifications Page 4